Garage door broken? Call (425) 426-2728 — free estimates on repair and replacement in Renton.

New garage door installation in Seattle, WA

New Garage Door Installation in Seattle, WA

In Seattle the door that fits is decided by headroom and side room long before it is decided by style.

  • Free estimate, price before we start
  • Most repairs finished in one visit
  • Door balanced and safety-tested before we leave

What is your door doing?

Free estimate. No obligation.

What is the problem?

By submitting you agree we may call or text you about this request. We do not sell your details.

What is going on

Four measurements before a quote

Opening width and height, headroom above the opening and side room beside it. Those four numbers decide the track configuration, the spring type and whether a rail operator can be used at all. Measuring the old door instead of the opening is how doors get ordered a couple of inches wrong.

Then weight and insulation, because a heavier door needs springs calculated for it rather than reused. On the install itself we set the door, balance it by hand, set the opener's limits and test the safety reverse on a real obstruction before we leave.

Seattle, WA

Measuring an opening that was never generous

Older garages here were built for one small car and not much else. Openings are often seven feet high, sometimes less, ceilings are low, and the space beside the opening can be a few inches. Those numbers set whether a standard-lift door is possible, whether it needs a low-clearance track, or whether the answer is a high-lift setup driven by a jackshaft.

On newer townhouse and infill builds the opening is standard but the garage is under living space. That puts insulation and noise at the top of the list rather than appearance, and a single-skin door is the wrong choice even though it costs less.

Symptoms

What a failing new garage door installation looks and sounds like

  • Door hits the ceiling on the way up

    Low headroom with standard-lift hardware. It needs a different track setup, not adjustment.

  • Old door is beyond economic repair

    Multiple failed sections, cracked stiles or unobtainable parts. Time to price a door.

  • Room above the garage is cold

    Single-skin door and an unsealed opening. An insulated door is part of the answer.

  • Door is loud in the house

    Thin panels and worn hardware. Insulation plus new rollers and a belt drive change that.

  • Curb appeal is dragging the whole facade

    On these narrow lots the door is a large share of the street frontage.

Why it happens in Seattle

Small original openings
Sixty-year-old garages built for one car, with clearances that limit what can be fitted.
Doors under living space
Townhouse garages where insulation and quiet matter more than the panel style.
Age and parts availability
When sections and hardware are no longer made, repair stops being the cheaper route.

What we check

What decides the door you can actually fit

The opening width and height are the easy part. What usually decides the specification is headroom above the door and space beside it, because those set whether you can have a standard-lift door, a high-lift door, or a low-headroom setup with a jackshaft operator. A door chosen without those numbers is a door that may not be able to open.

From there it comes down to insulation, glazing and finish. An insulated door in a garage under a bedroom changes how the room above feels and how loud the door is in the house. A single-skin door is fine for a detached shop. We would rather talk through that difference before the order than after.

  1. 01

    Opening dimensions

    Width and height taken at the opening, not from the old door, which may not have been the right size.

  2. 02

    Headroom

    Clearance above the door for the track curve and the opener rail, or the door goes high-lift instead.

  3. 03

    Side room

    Space beside the opening for the vertical track and the spring assembly.

  4. 04

    Insulation and glazing

    Single skin, insulated steel or a door with windows, which changes weight and needs matching springs.

  5. 05

    Spring sizing for the new weight

    Recalculated for the new door rather than reused, because a different door is a different load.

  6. 06

    Seal and threshold

    Bottom seal, perimeter seal and how the door meets an uneven or sloped concrete floor.

Safe to check yourself

  • Measure the opening width and height once to start a quote
  • Note the siding, trim colour and any HOA rules on door style
  • Clear the garage and the driveway before the crew arrives
  • Choose the style from a manufacturer design tool

Leave this to us in Seattle

  • Removal and disposal of the old door and hardware
  • Track, spring and operator installation
  • Balancing and safety reverse setup on the finished door
  • Any framing or trim work the opening needs

Our process

How we handle a call in Seattle

  1. 01

    Tell us what it is doing

    Call or send the form. The bang, the gap, the panel that will not close, the opener that quit. A photo helps us quote it faster.

  2. 02

    We diagnose on site

    Hand test, spring tension, cables, rollers, track and opener settings. We find the cause, not just the symptom.

  3. 03

    You approve the price

    Options and a firm price before work begins. If a repair will hold, we say so instead of quoting a new door.

  4. 04

    Fixed, tested, explained

    We finish the job, balance the door, set the opener and show you what was replaced and how it should run from now on.

Options and parts

What we fit, and what it changes

  • Standard-lift steel installation

    Where the opening and headroom allow it, insulated steel in a style that suits the facade.

  • Low-headroom configuration

    Low-clearance track and torsion hardware for garages with almost no ceiling.

  • Door and jackshaft operator together

    For low ceilings or overhead storage, with the operator sized to the finished door weight.

Why Seattle homeowners call us

  • Free estimate, zero pressure

    Send a photo or book a visit. You get a real number for your door before anyone touches it, and no obligation to book.

  • Upfront pricing, no surprises

    You approve the price before we start. Nothing gets added to the bill afterwards because the job turned out harder than expected.

  • Parts on the van

    Springs, cables, rollers and openers for most residential doors ride with us, so most repairs are finished in one visit.

  • Right spring for your door

    Springs are matched to the door's actual weight and height. The wrong one wears out fast and quietly strains the opener.

Coupons & special offers

Money off, before you even call

Print one, screenshot one, or just tell us the code. Every coupon here is honored on the phone and through the estimate form.

Newly installed two-car garage door on a residential home
$200off

Double garage door replacement

Both doors of a two-car garage replaced, with the old doors hauled away and disposed of.

DOUBLE200

Claim offer
Single-car garage door installed on a home
$150off

Single garage door replacement

A one-car door replaced with a new door we supply, measure and hang with our own crew.

SINGLE150

Claim offer
Broken garage door torsion spring
$125off

Spring replacement, pair

Both torsion springs replaced together, which is the only way they should be done.

SPRING125

Claim offer
New garage door opener motor mounted to the ceiling
$100off

Garage door opener installation

A new opener installed, connected and safety-tested, with a new wall control and remotes.

OPENER100

Claim offer

Claim any offer and it takes you straight to our estimate form. Mention the code when you call too. One coupon per job, not combined with another offer.

(425) 426-2728
Amarr Lincoln flush panel garage door
Flush and carriage styles both come in insulated steel. · Seattle, WA
Amarr Northwoods wood-look steel garage door
Wood-look steel, without the refinishing every few years. · Seattle, WA

Questions

Seattle questions we get asked

Can you deliver a door down a narrow alley?+

Yes, but tell us about access when you book. On tight lanes we hand-carry sections and may need someone to hold a gate or move a bin.

Do you take the old door away?+

Yes. Removal and haul-away are part of the quotation rather than an extra on the day.

How long does an installation take?+

A single door is usually a half day including removal. A double, or a door with a new operator, runs most of a day.

How long does an installation take?+

A single door is typically a half day including removal. A double door or a door with an opener added usually runs most of a day.

Do you take the old door away?+

Yes, removal and haul-away are part of the quote. Old doors and hardware go with us rather than being left at the curb.

Something not covered here? Call (425) 426-2728 and describe what the door is doing.

All garage door work in Seattle

Springs, cables, tracks, openers and new doors — the full picture for this city.

Garage door repair in Seattle, WA

The full new garage door installation guide

How this job works in detail, what the parts are and what we check.

New Garage Door Installation overview

Free estimate

Tell us what your garage door is doing

Describe the noise, the gap, or the part that gave out. We will tell you what it usually means, what it takes to fix it and what it costs — in Renton and the surrounding communities.